The function of a washer is to___________________?

A. provide cushioning effect
B. provide bearing area
C. absorb shocks and vibrations
D. provide smooth surface in place of rough surface
E. act as a locking device

Related Mcqs:

When a nut is tightened by plaping a washer below it, the bolt will be subjected to following type of loads___________________?
A. compression B. tension C. shear D. combined loads E. all of the above...
The function of cutting oil when threading a pipe is to___________________?
A. provide cooling action B. lubricate the dies C. help remove chips D. all of the above E. none of the above...
If a material fails below its yield point, failure would be due to___________________?
A. straining B. fatigue C. creep D. sudden loading E. impact loading...
If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to___________________?
A. diameter of bolt B. 0.75 x diameter of bolt C. 1.25 x diameter of bolt D. 1.5 x diameter of bolt E. 0.5 x diameter of bolt...
If the tearing efficiency of a riveted joint is 75%, then the ratio of diameter of rivet to the pitch is equal to___________________?
A. 0.2 B. 0.25 C. 0.50 D. 0.6 E. 0.75...
Endurance limit or fatigue limit is the maximum stress that a member can withstand for an infinite number of load applications without failure when subjected to________________?
A. dynamic loading B. static loading C. combined static and dynamic loading D. completely reversed loading E. all of the above...
A hot short metal is_________________?
A. brittle when cold B. brittle when hot C. brittle under all conditions D. ductile at high temperature E. hard when hot...
Machine screws are________________?
A. similar to small size tap bolts except that a greater variety of shapes of heads are available B. slotted for a screw driver and generally used with a nut C. used to prevent relative motion be-tween two parts D. similar to stud E. none of the above...
Whether any core is required in wire ropes________________?
A. yes B. no C. sometimes D. rarely E. very often...
Split nut is a locking device in which_________________?
A. one smaller nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming B. a slot is cut partly in middle of nut and then slot reduced by tightening screw C. a hard fiber or nylon cotter is recessed in the nut and becomes threaded as the...